You can build a strong DIY floating desk for small spaces in less than two hours using one pine board and two metal brackets. Mount the desk at twenty-nine inches from the floor to fit a standard office chair underneath without taking up any floor area. This simple project gives you a solid work surface while keeping your small room open and uncluttered.
How to Make a DIY Floating Desk for Small Spaces
Start by gathering your materials from a local home improvement store. You need a solid wood board that measures twelve inches deep, thirty-six inches wide, and one and a half inches thick. Pick up two heavy-duty steel shelf brackets rated to hold at least fifty pounds each, along with three-inch wood screws and wall anchors.
Preparation makes the installation fast and clean. Use seventy-grit sandpaper to smooth all edges of your wood board, then wipe away the dust with a dry cloth. Apply one coat of clear wood sealant or interior paint and let it dry for forty-five minutes before mounting.
- One solid pine board cut to twelve by thirty-six inches
- Two heavy-duty steel L-brackets with screw holes
- Six three-inch steel wall screws and matching wall anchors
- One roll of seventy-grit sandpaper for smooth edges
- One bottle of clear wood sealer or interior paint

Locate Wall Studs and Set Desk Height
Measure thirty inches up from the floor along your chosen wall and draw a light horizontal line with a pencil. Use an electronic stud finder along this line to locate two wooden wall studs spaced sixteen inches apart. Mark the exact center of each stud with a pencil point so your heavy-duty brackets anchor directly into solid wood.
Hold the first bracket against the wall with its top edge aligned to your pencil line. Insert a bubble level against the bracket side to ensure it sits completely straight. Mark the screw hole locations on the wall with your pencil, then repeat this exact process for the second bracket location sixteen inches away.
Mount the Brackets to the Wall
Drill pilot holes directly into your studs at each mark using a three-sixteenths inch drill bit. Pilot holes prevent the wood inside your walls from splitting when you drive the long screws into place. If your studs do not line up with your desk spot, install heavy-duty toggle bolts instead of standard wood screws.
Position the steel brackets over the drilled holes and drive the three-inch screws through the bracket holes using an electric screwdriver. Tighten each screw until the bracket sits flat against your drywall with zero wobble. Place your level across both mounted brackets to confirm they form a completely flat plane before attaching the wood top.
Attach the Wooden Desk Top
Set your sanded pine board directly on top of the mounted steel brackets. Adjust the board until it centers evenly, leaving two to four inches of wood overhanging past the outer side of each bracket. Clamp the board to the brackets using small plastic bar clamps so it does not shift while you secure it.
Drive three-quarter inch wood screws upward through the bottom holes of the metal brackets directly into the underside of the pine board. Check that these screws are short enough so they do not pierce through the top work surface. Remove the clamps, wipe down the surface, and your space-saving desk is ready for daily use.
- Set the board on top of the brackets and check overhang distances
- Clamp the wood down tightly to prevent movement while securing
- Drive short screws upward from underneath the steel bracket arm
- Check the top surface to ensure no screws poked through the wood
- Test the surface weight with a laptop and heavy books